GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Buick 🢒 2009 🢒 Enclave - AWD 🢒 Diagnostic Navigation 🢒 Vehicle Diagnostic Information 🢒 Camshaft Position Actuator Solenoid Valve Solenoid Replacement - Bank 2 (Left Side) Intake

Removal Procedure

    Object Number: 1856014 Size: SH
  1. Remove the engine mount strut bracket. Refer to Engine Mount Strut Bracket Replacement - Right Side.
  2. Remove the radiator inlet hose from the water outlet. Refer to Radiator Inlet Hose Replacement.
  3. Remove the power steering fluid reservoir bracket bolts (1).
  4. Remove and reposition the power steering fluid reservoir bracket (2) out of the way.

    5. Object Number: 1860429 Size: SH
  5. Disconnect the engine wiring harness electrical connector (6) from the bank 2 intake camshaft position (CMP) actuator solenoid valve.

    6. Object Number: 1860460 Size: SH
  6. Remove the CMP actuator solenoid valve bolt and valve (3).
  7. Inspect the CMP actuator solenoid valve seal for damage and replace as necessary.

Installation Procedure

    Object Number: 1860460 Size: SH
  1. Inspect the CMP actuator solenoid valve seal for damage. Replace the seal if necessary.

    2. Caution: Refer to Fastener Caution in the Preface section.

  2. Install the CMP actuator solenoid valve (3) and bolt.

    3. Tighten
    Tighten the bolt to 10 N·m (89 lb in).


    Object Number: 1860429 Size: SH
  3. Connect the engine wiring harness electrical connector (6) to the bank 2 intake CMP actuator solenoid valve.

    4. Object Number: 1856014 Size: SH
  4. Position and install the power steering fluid reservoir bracket (2).
  5. Install the power steering fluid reservoir bracket bolts (1).

    6. Tighten
    Tighten the bolts to 9 N·m (80 lb in).

  6. Install the radiator inlet hose to the water outlet. Refer to Radiator Inlet Hose Replacement.
  7. Install the engine mount strut bracket. Refer to Engine Mount Strut Bracket Replacement - Right Side.