Diagnostic Instructions
DTC Descriptors
DTC C0561 71: System Disabled Information Stored Invalid Serial Data Received
DTC C0561 72: System Disabled Information Stored Alive Counter Incorrect
DTC C0561 74: System Disabled Information Value of Signal Protection Calculation Incorrect
Circuit/System Description
The electronic brake control module (EBCM) receives serial data messages from the body control module (BCM), engine control module (ECM), instrument panel cluster (IPC), and the transmission control module (TCM) which are needed to perform antilock brake
system (ABS), vehicle stability enhancement system (VSES), or traction control system (TCS) functions.
Conditions for Running the DTC
Ignition voltage is greater than 10 volts.
Conditions for Setting the DTC
The EBCM receives an invalid serial data message from another module.
Action Taken When the DTC Sets
• | The EBCM disables the traction control system (TCS)/ vehicle stability enhancement system (VSES). |
• | A DIC message and/or a warning indicator may be displayed. |
Conditions for Clearing the DTC
• | The condition for the DTC is no longer present. |
• | The EBCM clears the history DTC when a current DTC is not detected in 100 consecutive drive cycles. |
Diagnostic Aids
This DTC indicates that there are no problems in the EBCM. The BCM, ECM, IPC and the TCM should be checked for a possible fault.
Reference Information
Schematic Reference
Antilock Brake System Schematics
Connector End View Reference
Component Connector End Views
Description and Operation
ABS Description and Operation
Electrical Information Reference
Scan Tool Reference
Control Module References for scan tool information
Circuit/System Verification
- With a scan tool, view the Invalid Signal Data Display.
- If no invalid signal are present, view Signal Fault Data in the Enhanced DTC Data.
- Refer to appropriate module for diagnosing the invalid message data.
- Do not replace the EBCM due to this DTC fault.