GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Buick 🢒 2009 🢒 Enclave - AWD 🢒 Body Repair 🢒 Collision Repair 🢒 Quarter Panel Filler Replacement - Lower

Removal Procedure

    Warning: Refer to Approved Equipment for Collision Repair Warning in the Preface section.


    Object Number: 1831213 Size: SH
  1. Disable the supplemental inflatable restraint (SIR) system. Refer to SIR Disabling and Enabling.
  2. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection.
  3. Remove all related panels and components.
  4. Repair as much of the damage as possible to factory specifications. Refer to Dimensions - Body.
  5. Note the location and remove the sealers and anti-corrosion materials from the repair area, as necessary. Refer to Anti-Corrosion Treatment and Repair.

    6. Object Number: 1831216 Size: SH

    Note: Do not damage any inner panels or reinforcements.

  6. Locate and drill out all factory welds on the tail lamp filler panel. Note the number and location of the welds for installation of the tail lamp filler panel.

    7. Object Number: 1831219 Size: SH
  7. Remove the damaged tail lamp filler panel.

    8. Object Number: 1831231 Size: SH
  8. Locate and drill out all factory welds on the quarter filler panel. Note the number and location of the welds for installation of the quarter filler panel.

    9. Object Number: 1831221 Size: SH
  9. Remove the damaged quarter filler panel.

Installation Procedure
  1. Prepare all mating surfaces as necessary.
  2. Apply GM-approved Weld-Thru Coating or equivalent to all mating surfaces. Refer to Anti-Corrosion Treatment and Repair.

    3. Object Number: 1831236 Size: SH
  3. Position the quarter filler panel to the vehicle using 3-dimensional measuring equipment. Clamp the quarter filler panel into place.

    4. Object Number: 1831239 Size: SH
  4. Plug weld accordingly.

    5. Object Number: 1831242 Size: SH
  5. Position the tail lamp filler panel to the vehicle using 3-dimensional measuring equipment. Clamp the tail lamp filler panel into place.

    6. Object Number: 1831244 Size: SH
  6. Plug weld accordingly.
  7. Clean and prepare all welded surfaces.
  8. Apply the sealers and anti-corrosion materials to the repair area, as necessary. Refer to Anti-Corrosion Treatment and Repair.
  9. Paint the repair area. Refer to Basecoat/Clearcoat Paint Systems.
  10. Install all related panels and components.
  11. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection.
  12. Enable the SIR system. Refer to SIR Disabling and Enabling.