The fuel pump flow control module (FPCM) controls and monitors the operation of the fuel system. When the FPCM detects a fault and sets a DTC, the FPCM sends a serial data message to the engine control module (ECM) requesting the illumination of the malfunction indicator lamp (MIL). This DTC sets in the ECM when it receives a MIL request message from the FPCM.

The ECM receives a serial data message from the FPCM, in order to illuminate the MIL.

DTC P069E is a Type A DTC.

DTC P069E is a Type A DTC.

Using the Failure Records data may help locate an intermittent condition. If you cannot duplicate the DTC, the information in the Failure Records can help determine how many miles since the DTC set. The Fail Counter and Pass Counter can help determine how many ignition cycles that the diagnostic test reported a pass and/or a fail.

Schematic Reference

Engine Controls Schematics

Connector End View Reference

Component Connector End Views

Electrical Information Reference

DTC Type Reference

Powertrain Diagnostic Trouble Code (DTC) Type Definitions

Scan Tool Reference

Control Module References for scan tool information

1. DTC P069E is an informational DTC. If there are no Engine Controls DTCs, refer to Diagnostic Trouble Code (DTC) List - Vehicle for diagnosis of the FPCM.
2. Operate the vehicle within the Conditions for Running the DTC to verify the DTC does not reset. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.