For 1990-2009 cars only
Removal Procedure
- Remove the IP compartment latch. Refer to Instrument Panel Compartment Door Latch Replacement .
- Set the latch fork bolt in the UP position.
- Insert the key into the lock cylinder.
- Rotate the lock cylinder clockwise to the 3 o'clock position with the key.
- With the key in position, apply a light load and depress the retainer tumbler through the poke hole at the right hand side of the latch.
- Rotate the key until the lock cylinder rotates to about the 5 o'clock position.
- Remove the following components from the latch:
This will line up the notch at the rear of the lock cylinder with the tab in the latch housing.
| • | The IP compartment lock cylinder |
| • | The key |
Installation Procedure
- Set the IP compartment latch fork bolt in the UP position.
- Grasp the lock cylinder. Depress the rear-most, light-colored tumbler that is flush with the lock cylinder surface.
- Insert the key.
- Insert the lock cylinder, with the key inserted, into the latch housing. Ensure that the front projection pin is at the appropriate 8 o'clock position.
- Rotate the key counterclockwise until the key stops.
- Remove the key.
- Install the latch. Refer to Instrument Panel Compartment Door Latch Replacement .
All tumblers will now stay depressed.
The lock cylinder will drop into place.
The lock cylinder is now locked into the latch housing.
