Tools Required

J 38864 Counterbalance Spring Removal and Installation Tool

1. Remove the front door trim panel. Refer to Door Trim Panel Replacement .
2. Remove the front door water deflector. Refer to Front Side Door Water Deflector Replacement .
3. Apply the cloth backed body tape from the window over the top of the door to the other side of the window in order to hold the window in position when the removing the regulator.
4. Remove the wiring harness from the regulator motor.

Important: Draw a line across the spring through the center with a marker or grease pencil in order to aid in the re-installation and orientation of the counterbalance spring.

5. Use J 38864 to walk down the spring tension.



6. Unsnap the power window motor in order to remove the power window motor from the lock module.

Tools Required

J 38864 Counterbalance Spring Removal and Installation Tool

1. Lubricate the motor drive gear and the regulator sector teeth.



2. Snap the power window motor to the lock module in order to install the power window motor.

Important: Ensure the marker or grease pencil line from the removal procedure is lined up. Lining up the mark will set the correct pre-tension of the counterbalance spring.

3. Use the J 38864 to install the counterbalance spring.
4. Install the wiring harness to the regulator motor.
5. Install the front door water deflector. Refer to Front Side Door Water Deflector Replacement .
6. Install the front door trim panel. Refer to Door Trim Panel Replacement .