Removal Procedure
- Remove the coolant recovery reservoir. Refer to
Coolant Recovery Reservoir Replacement
.
- Remove the drive belt. Refer to
Drive Belt Replacement
.
- Disconnect the electrical connector (2) from the camshaft position sensor (1).
- Remove the camshaft position sensor bolt.
- Remove the camshaft position sensor from the engine front cover.
Installation Procedure
- Install the camshaft position sensor to the engine front cover.
Notice: Use the correct fastener in the correct location. Replacement fasteners
must be the correct part number for that application. Fasteners requiring
replacement or fasteners requiring the use of thread locking compound or sealant
are identified in the service procedure. Do not use paints, lubricants, or
corrosion inhibitors on fasteners or fastener joint surfaces unless specified.
These coatings affect fastener torque and joint clamping force and may damage
the fastener. Use the correct tightening sequence and specifications when
installing fasteners in order to avoid damage to parts and systems.
- Install the camshaft position sensor bolt.
Tighten
Tighten the bolt to 10 N·m (89 lb in).
- Connect the electrical connector (2) to the camshaft position sensor (1).
- Install the drive belt. Refer to
Drive Belt Replacement
.
- Install the coolant recovery reservoir. Refer to
Coolant Recovery Reservoir Replacement
.