Removal Procedure
- Turn the ignition OFF.
- Remove the closeout/insulator panel from under the dashboard on the drivers
side. Refer to
Instrument Panel Insulator Panel Replacement - Left Side
in Instrument Panel, Gages, and Console.
Notice: Handle the electronic throttle control components carefully. Use cleanliness
in order to prevent damage. Do not drop the electronic throttle control components.
Do not roughly handle the electronic throttle control components. Do
not immerse the electronic throttle control components in cleaning solvents
of any type.
- Disconnect the accelerator pedal position (APP) sensor electrical connector
from the accelerator pedal module.
- Remove the APP sensor mounting bolts.
- Remove the APP sensor from the vehicle.
Installation Procedure
- Position the APP sensor to the mounting
plate.
Notice: Refer to Fastener Notice in the Preface section.
- Install the APP sensor mounting bolts.
Tighten
Tighten the APP sensor mounting bolts to 10 N·m
(89 lb in).
- Connect the APP sensor electrical connector.
- Operate the accelerator pedal and observe the APP angles using a scan
tool. The accelerator pedal should operate freely, without binding between closed
throttle and wide open throttle.
- Install the closeout/insulator panel. Refer to
Instrument Panel Insulator Panel Replacement - Left Side
in Instrument Panel, Gages
and Console.