Removal Procedure
- Remove the instrument panel lower trim plate. Refer to
Instrument Panel Lower Trim Plate Replacement
in Instrument Panel, Gages, and Console.
- Remove the HVAC control assembly mounting screws (1).
Important: Retaining clips hold the HVAC control assembly in place.
- Pull the HVAC control assembly rearward from the instrument panel.
- Disconnect the electrical connectors form the HVAC control assembly.
- Remove the HVAC control assembly.
Installation Procedure
Important: The key should be in the off position when connecting the electrical connectors to ensure proper calibration.
- Connect the electrical connectors to the HVAC control assembly.
- Install the HVAC control assembly.
Notice: Refer to Fastener Notice in the Preface section.
- Install the HVAC control assembly mounting screws.
Tighten
Tighten the screws to 2 N·m (18 lb in).
- Install the instrument panel lower trim plate. Refer to
Instrument Panel Lower Trim Plate Replacement
in Instrument Panel, Gages, and Console.
Important: Do not adjust any controls on the HVAC control assembly while the HVAC control assembly is calibrating. If interrupted improper HVAC performance will result.
- Start the engine and run for 1 minute.