Important: Both mechanisms should now be in the closed position.
Notice: Refer to Fastener Notice in the Preface section.
Tighten
Tighten the screws to 4 N·m (35 lb in).
Important: Before installing the sunroof opening position switch, inspect the timing window. The small hole must be in line with the bar, as shown. If the hole is not aligned with the bar, rotate the gear by hand left or right until the hole and the bar are in position.
Tighten
Tighten the motor/actuator attachment screws to 3.5 N·m (31 lb in).
Important: If the sunroof does not function properly, and the guides are parallel, then replace the sunroof opening switch.