GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Buick 🢒 2006 🢒 LaCrosse 🢒 Body 🢒 Wiring Systems 🢒 Torque Converter Clutch Pulse Width Modulation Solenoid Replacement

Removal Procedure

    Object Number: 48209 Size: SH
  1. Remove the case side cover. Refer to Control Valve Body Cover Replacement .
  2. Disconnect and reposition the electrical connectors from the following:
    3. • If equipped internal mode switch
    • 2-3 Shift solenoid valve assembly (315B)
    • Automatic transaxle fluid pressure manual valve position switch assembly (395)

    Object Number: 893320 Size: SH
  3. Remove the oil pump bolts (230, 231).

    4. Object Number: 893321 Size: SH
  4. Remove the oil pump (200) from the valve body (300).

    5. Object Number: 49380 Size: SH
  5. Disconnect the torque converter clutch pulse width modulation (TCC PWM) solenoid electrical connector.
  6. Remove the TCC PWM solenoid retaining clip (314F).
  7. Remove the TCC PWM solenoid (334).

Installation Procedure

    Object Number: 49380 Size: SH
  1. Install the TCC PWM solenoid (334).
  2. Install the TCC PWM solenoid retaining clip (314F).
  3. Connect the TCC PWM solenoid electrical connector.

    4. Object Number: 893321 Size: SH
  4. Install the oil pump (200) to the valve body (300).

    5. Notice: Refer to Fastener Notice in the Preface section.


    Object Number: 893320 Size: SH
  5. Install the oil pump body and cover bolts (230, 230).

    6. Tighten

        • Tighten the nine bolts (231) to 12 N·m (106 lb in).
        • Tighten the two bolts (230) to 16 N·m (12 lb ft).

    Object Number: 48209 Size: SH
  6. Reposition and connect the electrical connectors to the following:
    7. • Automatic transaxle fluid pressure manual valve position switch assembly (395)
    • 2-3 Shift solenoid valve assembly (315B)
    • If equipped internal mode switch
  7. Install the case side cover. Refer to Control Valve Body Cover Replacement .

    8. Important: It is recommended that transmission adaptive pressure (TAP) information be reset. Resetting the TAP values using a scan tool will erase all learned values in all cells. As a result, The ECM, PCM or TCM will need to relearn TAP values. Transmission performance may be affected as new TAP values are learned.

  8. Reset the TAP values. Refer to Transmission Adaptive Functions .