Caution: Refer to Brake Dust Caution in the Preface section.

1. Remove the brake caliper from the mounting bracket and support the brake caliper (2) with heavy mechanic's wire (1), or equivalent. Discard the old caliper pin bolts, new bolts are supplied in the hardware kit. It is not necessary to disconnect the hydraulic brake flexible hose from the caliper. Refer to Front Brake Caliper Replacement.



2. Remove the brake pads (2) from the brake caliper bracket.
3. Remove the brake pad retainers (1) from the brake caliper bracket.



4. Remove the brake caliper bracket. Refer to Front Brake Caliper Bracket Replacement.
5. Mount the brake caliper bracket (1) in a vise.
6. Using a flat-bladed tool or punch carefully remove the caliper pin boots (2) from brake caliper bracket (1).

Important: 

•	Clean the caliper bracket with denatured alcohol.

•	Dry with low pressure, non-lubricated, filtered air.

•	Inspect the brake caliper bracket for damage. If damaged, replace the bracket.

7. Thoroughly clean the caliper bracket bores of all lubricant.

1. Lubricate the bores (3), the inside part of the bolt boot (2) and the caliper pin bolts (4) with GM P/N 18047666, or equivalent.
2. Press the new caliper pin bolt boots into the caliper pin bores.
3. Install the brake caliper bracket. Refer to Front Brake Caliper Bracket Replacement.



4. Install the brake pad retainers (1) to the caliper bracket.
5. Install the brake pads (2) to the caliper bracket.



6. Remove the heavy mechanics wire (1) and install the brake caliper. Refer to Front Brake Caliper Replacement.