Circuit Description
Ground is applied by the turn signal switch. When the turn signal switch is placed in the turn left position, ground is applied to the body control module (BCM) through the left turn signal switch circuit. The BCM then applies a pulsating voltage to the LF and LR turn signal lamps through the LF and LR turn signal lamp supply voltage circuits.
DTC Descriptor
This diagnostic procedure supports the following DTC:
DTC B3950 Left Rear Turn Signal Circuit
Conditions for Running the DTC
The battery voltage must be between 9-16 volts.
Conditions for Setting the DTC
A short to ground or an open in the LR turn signal lamp supply voltage circuit is present for longer then 0.1 seconds.
Action Taken When the DTC Sets
The left rear turn signal lamp does not work.
Conditions for Clearing the DTC
| • | The DTC will clear on current status after the condition for setting the fault is corrected. |
| • | Will set a history code which will clear after 100 consecutive ignition cycles without a fault present. |
| • | History and current DTCs can be cleared using a scan tool. |
Diagnostic Aids
| • | Check the LR turn lamp bulb. If the bulb is open, DTC B3950 will be set. |
| • | If the DTC is a history DTC, the fault may be intermittent. Refer to Testing for Intermittent Conditions and Poor Connections . |
| • | An intermittent short to ground or an open in the following locations may cause an intermittent malfunction to occur: |
| - | The BCM |
| - | The left rear turn signal lamp supply voltage circuit |
Step | Action | Yes | No |
|---|---|---|---|
Schematic Reference: Exterior Lights Schematics Connector End View Reference: Master Electrical Component List | |||
1 | Did you perform the Diagnostic System Check - Vehicle? | Go to Step 2 | |
2 |
Do the rear turn signal lamps flash on and off? | Go to Testing for Intermittent Conditions and Poor Connections | Go to Step 3 |
3 |
Does the test lamp illuminate? | Go to Step 6 | Go to Step 4 |
4 |
Did you find and correct the condition? | Go to Step 8 | Go to Step 5 |
5 | Inspect for a high resistance or an open at the harness connector of the BCM. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs . Did you find and correct the condition? | Go to Step 8 | Go to Step 7 |
6 | Repair a short to ground in the LR turn signal lamp supply voltage circuit. Refer to Circuit Testing and to Wiring Repairs . Did you complete the repair? | Go to Step 8 | -- |
7 | Replace the BCM. Refer to Control Module References for replacement, setup, and programming. Did you complete the replacement? | Go to Step 8 | -- |
8 |
Does the DTC reset? | Go to Step 2 | System OK |
