Removal Procedure
- Drain the cooling system. Refer to
Cooling System Draining and Filling.
- Disconnect the left knock sensor electrical connector, if required.
- Remove the left knock sensor bolt, if required.
- Remove the left knock sensor, if required.
- Disconnect the right knock sensor electrical connector (2), if required.
- Remove the right knock sensor bolt, if required.
- Remove the right knock sensor, if required.
Installation Procedure
- Position the right knock sensor to the engine block, if required.
Caution: Refer to Fastener Caution in the Preface section.
- Install the right knock sensor bolt, if required.
Tighten
Tighten the bolt to 20 N·m (15 lb ft).
- Connect the right knock sensor electrical connector (2), if required.
- Position the left knock sensor to the engine block, if required.
- Install the left knock sensor bolt, if required.
Tighten
Tighten the bolt to 20 N·m (15 lb ft).
- Connect the left knock sensor electrical connector, if required.
- Fill the cooling system. Refer to
Cooling System Draining and Filling.