Diagnostic Instructions
| • | Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure. |
| • | Review Strategy Based Diagnosis for an overview of the diagnostic approach. |
| • | Diagnostic Procedure Instructions provides an overview of each diagnostic category. |
DTC Descriptor
DTC B3873 00: Front Washer Relay CircuitDiagnostic Fault Information
Circuit | Short to Ground | Open/High Resistance | Short to Voltage | Signal Performance |
|---|---|---|---|---|
Windshield Washer Switch Signal | 2 | 1 | 3 | -- |
Windshield Washer Pump Control | B3873 00 | 1 | 2 | -- |
Windshield Wiper/Washer Switch Low Reference | -- | 1 | -- | -- |
Windshield washer Pump Ground | -- | 3 | -- | -- |
1. Washer Inoperative 2. Washers Always ON 3. Windshield Wiper System Malfunction | ||||
Circuit/System Description
The windshield washer function is controlled by the body control module (BCM). When the washer switch is pressed, ground is applied through the switch contacts and the signal circuit to the BCM indicating the wash request. The BCM then applies ground through the control circuit to the coil side of the WS WASH relay energizing the relay. With the relay energized, battery voltage from the WPR fuse is applied through the switch contacts of the relay, the WSW fuse and the control circuit to the windshield washer fluid pump.
Conditions for Running the DTC
This DTC can set only when the output is actively being requested by the BCM.
Conditions for Setting the DTC
This DTC sets if the BCM detects a short to ground in the wiper high speed relay control circuit.
Action Taken When the DTC Sets
The BCM will not activate the output.
Conditions for Clearing the DTC
| • | The current DTC will become history when the request for the output is removed or when the condition for setting the fault is corrected. |
| • | The history DTC will clear after 50 consecutive ignition cycles without a fault present. |
Reference Information
Schematic Reference
Connector End View Reference
Description and Operation
Wiper/Washer System Description and Operation
Electrical Information Reference
Scan Tool Reference
Control Module References for Scan Tool Information
Circuit/System Testing
- Ignition OFF, disconnect the harness connector at the windshield washer fluid pump..
- Verify there is less than 2Ω between ground terminal B and ground
- Connect a test lamp between the control circuit terminal A and ground.
- Command the Wiper Washer Motor ON and OFF with a scan tool. The test lamp should turn ON and OFF when changing between the commanded states.
- If all circuits test normal, test or replace the underhood fuse block.
| ⇒ | If not the specified value, test the ground circuit for an open/high resistance. |
| ⇒ | If the test lamp is always ON, test the control circuit for a short to B+. If the circuit tests normal, replace the body control module. |
| ⇒ | If the test lamp is always OFF, test the control circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace the body control module. |
Repair Instructions
Perform the Diagnostic Repair Verification after completing the diagnostic procedure.
| • | Control Module References for BCM replacement, setup, and programming |
