BACK WINDOW MLDG. APPEARANCE (INSTALL NEW MOLDING)

SUBJECT: BACK WINDOW REVEAL MOLDING APPEARANCE (INSTALL NEW HOLDING)

MODELS AFFECTED: 1992 LESABRE

CONDITION:

---------- The 1992 LeSabre models may exhibit a poor appearance of the back window molding due to shrinkage.

CORRECTION:

----------- 1. To replace the upper back window molding, use part number 25602834. To replace the lower back window molding, use part number 25602835 on all vehicles except those equipped with the vinyl top, Option CB-5. Vehicles equipped with a vinyl top require part number 25602836.

2. Remove the upper molding. Assure the molding retainer is clean and dry. Apply a light bead of Loctite 380 (Black Max) or Loctite 410 or equivalent adhesive in one inch beads in locations shown in Figure 1. Apply only enough adhesive to assure proper retention.

3. Center and install the new molding.

IF NECESSARY TO REPLACE THE LOWER MOLDING

1. Remove the lower reveal molding. Assure the molding retainer is clean and dry. Apply Loctite 380 (Black Max) or Loctite 410 or equivalent in one inch lengths in areas noted on Figure 1.

2. Center and install the lower reveal molding.

Parts are currently available from GMSPO.

WARRANTY INFORMATION:

Labor Operation Numbers: Upper Molding B8520 Lower Molding B8540 Labor Time: .3 hr.

General Motors bulletins are intended for use by professional technicians, not a "do-it-yourselfer". They are written to inform those technicians of conditions that may occur on some vehicles, or to provide information that could assist in the proper service of a vehicle. Properly trained technicians have the equipment, tools, safety instructions and know-how to do a job properly and safely. If a condition is described, do not assume that the bulletin applies to your vehicle, or that your vehicle will have that condition. See a General Motors dealer servicing your brand of General Motors vehicle for information on whether your vehicle may benefit from the information.