--------- Some owners of 1991-92 C and H models may experience a wavy or warped appearing instrument panel upper trim panel. Following are the various causes and their corrections:
CONDITION: Refer to Figure 1 --------- Localized dip in the centre of upper trim panel at forward edge.
o Remove upper trim panel o Rework centre-forward locating hole on I/P carrier appropriate amount to level upper trim panel o Replace panel if waviness set has been taken o Reattach upper trim panel
CONDITION: Refer to Figure 2. --------- Upper trim panel high at forward edge.
o Remove upper trim panel o Evaluate if panel was installed correctly (with tabs on upper trim panel properly inserted into slots of I/P carrier) o If incorrect assembly: Re-install panel correctly and fasten down o If assembly was correct: Remove felt wrap from locating tab, remove shim located on tab, reattach shim to top side of tab, recover with felt, reinstall panel to I/P.
CONDITION: Refer to Figure 3. --------- Rearward edge of upper trim panel high to I/P right of centre
o Remove glove box assembly o Loosen I/P centre support bolts o Adjust I/P height in centre to give good appearance to upper trim panel o Re-tighten fasteners
Labour Time: .3 hr.
Labour Time: .3 hr.
General Motors bulletins are intended for use by professional technicians, not a "do-it-yourselfer". They are written to inform those technicians of conditions that may occur on some vehicles, or to provide information that could assist in the proper service of a vehicle. Properly trained technicians have the equipment, tools, safety instructions and know-how to do a job properly and safely. If a condition is described, do not assume that the bulletin applies to your vehicle, or that your vehicle will have that condition. See a General Motors dealer servicing your brand of General Motors vehicle for information on whether your vehicle may benefit from the information.