- Disassemble the manual valve link and spring from the manual shift detent
lever.
- Remove the nut (803) for the manual shift detent lever from the
manual shift shaft (807).
- Remove the manual shift detent lever (802) and remove the park
pawl actuator assembly (800).
- Use side cutting pliers in order to remove the manual shift shaft pin (801):
• | Do not cut through the pin |
• | Protect the case with a piece of wood or rubber |
- Position the transmission so that the reverse band servo bore is facing upward.
- Pull the manual shift shaft (807) out of the case.
- Use a small screwdriver in order to pry the manual shift shaft
seal (806) from the case:
- Remove the park pawl actuator guide pin (808).
- Remove the park pawl actuator guide assembly (809) from the case.
- Remove the actuator guide seal (810) from the guide.