GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Buick 🢒 2000 🢒 LeSabre 🢒 Steering 🢒 Steering Wheel and Column - Tilt 🢒 Shift Lever Replacement - On Vehicle

Removal Procedure

    Object Number: 470484 Size: SH

    Caution: This vehicle is equipped with a Supplemental Inflatable Restraint (SIR) System. Failure to follow the correct procedure could cause the following conditions:

       • Air bag deployment
       • Personal injury
       • Unnecessary SIR system repairs
    In order to avoid the above conditions, observe the following guidelines:
       • Refer to SIR Component Views in order to determine if you are performing service on or near the SIR components or the SIR wiring.
       • If you are performing service on or near the SIR components or the SIR wiring, disable the SIR system. Refer to Disabling the SIR System.

    Caution: Unless directed otherwise, the ignition and start switch must be in the OFF or LOCK position, and all electrical loads must be OFF before servicing any electrical component. Disconnect the negative battery cable to prevent an electrical spark should a tool or equipment come in contact with an exposed electrical terminal. Failure to follow these precautions may result in personal injury and/or damage to the vehicle or its components.

  1. Disconnect the negative battery cable.
  2. Disable the SIR system. Refer to Disabling the SIR System in Restraints.
  3. Remove the steering wheel. Refer to Steering Wheel Replacement
  4. Remove the steering column shrouds. Refer to Steering Column Trim Covers - Disassemble - Off Vehicle .
  5. Remove the left closeout/insulator panel (if equipped with traction control). Refer to Instrument Panel Insulator Panel Replacement - Left Side in Instrument Panel, Gauges and Console.
  6. Disconnect electrical connector from traction control harness if equipped and feed harness out of column. Observe the harness routing and location to assist in reassembly.
  7. Remove the Torx® head fastener from the shift lever to shift control.
  8. Pull the shift lever upward to remove it from the shift control.

Installation Procedure

    Object Number: 470484 Size: SH
  1. Push the shift lever downward to engage it into the shift control.
  2. Install the Torx® head fastener.
  3. Feed the traction control harness (if equipped) back throught the column. Use care to route the harness as previously observed.
  4. Install the steering column shrouds. Refer to Steering Column Trim Covers - Assemble - Off Vehicle .
  5. Install the steering column. Refer to Steering Wheel Replacement .
  6. Install the left closeout/insulator panel (if equipped with traction control). Refer to Instrument Panel Insulator Panel Replacement - Left Side in Instrument Panel, Gauges and Console.
  7. Enable the SIR system. Refer to Enabling the SIR System in Restraints.