GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Buick 🢒 2000 🢒 LeSabre 🢒 Restraints 🢒 SIR 🢒 Front Seat Replacement - Bucket

Removal Procedure

    Caution: Refer to SIR Handling Caution in the Preface section.

  1. Disable the SIR system. Refer to Disabling the SIR System in SIR.
  2. Move the seat to the full forward position.

    3. Object Number: 291625 Size: SH
  3. Remove the rear seat track fastener trim cover on the inboard seat track.

    4. Object Number: 430372 Size: SH
  4. Remove the rear seat track trim cover (1) from the outboard seat track.

    5. Object Number: 430375 Size: SH
  5. Remove the seat track fastener trim cover (1) on the outboard track by pushing the cover out from the inside of the seat track with a flat bladed tool.

    6. Object Number: 469175 Size: SH
  6. Remove the seat track fasteners.

    7. Object Number: 470256 Size: SH
  7. Move the seat to the full rearward position.
  8. Remove the front seat track fastener trim covers.
  9. Remove the front seat track fasteners.

    10. Object Number: 470257 Size: SH
  10. Disconnect the electrical connectors.
  11. Remove the seat from the vehicle.

Installation Procedure
  1. Install the seat into the vehicle.

    2. Object Number: 470257 Size: SH
  2. With seat tilted forward, connect the electrical connectors.

    3. Object Number: 469175 Size: SH

    Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  3. Lower the rear of the seat and install the fasteners.

    4. Tighten
    Tighten the seat fasteners to 30 N·m (22 lb ft).


    Object Number: 291625 Size: SH
  4. Install the seat track fastener trim covers.

    5. Object Number: 470256 Size: SH
  5. Install the forward seat track fasteners.

    6. Tighten
    Tighten the seat fasteners to 30 N·m (22 lb ft).

  6. Install the front seat track cover.
  7. Reposition the seat.
  8. Enable the SIR system. Refer to Enabling the SIR System in Seat Belts.