GM Service Manual Online
For 1990-2009 cars only

Step

Action

Value(s)

Yes

No

1

Did you perform the Lighting Systems Diagnostic System Check?

--

Go to Step 2

Go to Diagnostic System Check - Lighting Systems

2

  1. Install a scan tool.
  2. Turn ON the ignition, with the engine OFF.
  3. Turn ON the interior lamp switch.
  4. With a scan tool, observe the interior lamp switch parameter in the climate control panel (CCP) (w/C67) or the instrument panel module (IPM) (w/CJ2) data list.

Does the scan tool display ON?

--

Go to Step 7

Go to Step 3

3

  1. Turn OFF the ignition.
  2. Disconnect the headlamp switch.
  3. Connect a 3 amp fused jumper wire between the signal circuit of the interior lamp switch and the ground circuit.
  4. Turn ON the ignition, with the engine OFF.
  5. With a scan tool, observe the Interior Lamp Switch parameter.

Does the scan tool display ON?

--

Go to Step 5

Go to Step 4

4

Test the signal circuit of the interior lamp switch for a high resistance or an open. Refer to Circuit Testing and Wiring Repairs in Wiring Systems.

Did you find and correct the condition?

--

Go to Step 9

Go to Step 7

5

Inspect for poor connections at the connector of the headlamp switch. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems.

Did you find and correct the condition?

--

Go to Step 9

Go to Step 6

6

Replace the headlamp switch. Refer to Headlamp Switch Replacement .

Did you complete the replacement?

--

Go to Step 9

--

7

Inspect for poor connections at the connector of the CCP or the IPM (w/CJ2). Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems.

Did you find and correct the condition?

--

Go to Step 9

Go to Step 8

8

Replace the CCP or the IPM (w/CJ2). Refer to Control Module References in Body Control System.

Did you complete the replacement?

--

Go to Step 9

--

9

Operate the system in order to verify the repair.

Did you find and correct the condition?

--

System OK

Go to Step 2