GM Service Manual Online
For 1990-2009 cars only

Step

Action

Value(s)

Yes

No

1

Did you perform the Wiper/Washer System Check?

--

Go to Step 2

Go to Wiper/Washer System Check or Wiper/Washer System Check

2

  1. Disconnect the harness connector from the wiper motor.
  2. Turn the ignition to RUN.
  3. Set the wiper switch to HI.
  4. Connect a test lamp between the high speed input circuit of the wiper motor connector and a good ground.

Does the test lamp illuminate?

--

Go to Step 3

Go to Step 5

3

Inspect for poor connections at the harness connector of the wiper motor. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems.

Did you find and correct the condition?

--

Go to Step 8

Go to Step 4

4

Replace the wiper motor. Refer to Windshield Wiper Motor Replacement .

Is the replacement complete?

--

Go to Step 8

--

5

Test the high speed input circuit of the wiper motor for an open. Refer to Circuit Testing and Wiring Repairs in Wiring Systems.

Did you find and correct the condition?

--

Go to Step 8

Go to Step 6

6

Inspect for poor connections at the harness connector of the wiper/washer switch. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems.

Did you find and correct the condition?

--

Go to Step 8

Go to Step 7

7

Replace the wiper/washer switch. Refer to Multifunction Turn Signal Lever Replacement - On Vehicle .

Is the replacement complete?

--

Go to Step 8

--

8

Operate the wiper/washer system and inspect for proper operation.

Did you correct the condition?

--

System OK

Go to Wiper/Washer System Check or Wiper/Washer System Check