Step | Action | Value(s) | Yes | No |
|---|---|---|---|---|
1 | Did you perform the Door Systems Diagnostic System Check? | -- | Go to Step 2 | |
2 |
Do locks operate as expected for mode selected? | -- | Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems | Go to Step 3 |
3 | With the scan tool, observe the Door Jamb Sw. parameter of each door in the Driver Door Module Inputs list. Does the scan tool indicate that the Door Jamb Sw. parameter is in the OFF state for all doors? | -- | Go to Step 4 | Go to Step 8 |
4 | Replace the rear integration module (RIM). Refer to Rear Integration Body Control Module Replacement . Did you complete the replacement? | -- | Go to Step 5 | -- |
5 | Close all doors and shift out of park, shift into park and turn ignition switch off. Do doors lock and unlock when shifting? | -- | Go to Step 6 | Go to Step 9 |
6 | Was mode 3 the mode selected for the transmitter as read in Step 2? | -- | Go to Step 9 | Go to Step 7 |
7 |
Did you complete the operation? | -- | Go to Step 9 | -- |
8 | Test for and repair short to ground on the door jamb/open circuit of the suspect door(s). Did you complete the repair? | -- | Go to Step 9 | -- |
9 | Operate the system in order to verify the repair. Did you correct the condition? | -- | System OK | Go to Step 2 |
