Removal Procedure
- If possible, close the sunroof window before removing the sunroof actuator motor.
- Lower the formed headliner at the rear in order to access the sunroof actuator motor. Refer to Headlining Trim Panel Replacement in Interior Trim.
- Disconnect the electrical connectors (3) from the sunroof actuator motor (1).
- Remove the bolts (5) securing the sunroof actuator motor (1) to the sunroof module assembly (2).
- Remove the sunroof actuator motor from the sunroof module assembly.
Important: Do not apply battery voltage to a new sunroof actuator motor prior to installing the actuator motor to the sunroof module assembly. The sunroof window must be in the full closed position.
Installation Procedure
- Manually move the sunroof window to the full closed position.
- Install the sunroof actuator motor (1) to the sunroof module assembly (2).
- Install the bolts in order to secure the sunroof actuator motor to the sunroof module.
- Connect the electrical connectors (3) to the sunroof actuator motor (1).
- Check the window fit to the roof opening. Refer to Sunroof Window Height and Opening Fit Adjustment .
- Install the headliner. Refer to Headlining Trim Panel Replacement in Interior Trim.
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the bolts to 5 N·m (44 lb in).
Important: Verify the sunroof operation before installing the headliner.
