For 1990-2009 cars only
- Install the trim cover protector (1) to the lower trim cover (2).
- Install the closeout trim cover (2) onto the upper trim cover (1).
- Install the upper trim cover (1) with the closeout trim cover (2) and secure by using 1 TORX® head screw (3).
- Slide the shift lever seal down the shift lever and secure into the upper trim cover.
- Install the lower trim cover (1).
- Make sure the shift lever seal is properly aligned in the upper and lower trim covers.
- Install 2 pan head tapping screws (2).
- Install the tilt lever (2) into the trim covers (1).
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the screw to 1.5 N·m (13 lb in).
Tighten
Tighten the screws to 3.5 N·m (31 lb in).
