For 1990-2009 cars only
Removal Procedure
- Remove the rear compartment sill plate. Refer to Rear Compartment Sill Trim Plate Replacement in Body Rear End.
- If removing the tail lamp for bulb replacement only, proceed to step 5.
- Disconnect the tail lamp connector.
- Press the grommet out of the rear end panel.
- Remove the fasteners securing the tail lamp assembly to the body.
- Remove the tail lamp assembly from the body.
- Twist the tail lamp socket counter clockwise to remove.
- Replace the failed bulbs, if necessary.
Installation Procedure
- If the tail lamp was removed for bulb replacement only, proceed to step 4.
- Route the tail lamp connector and the grommet through the body.
- Verify that the grommet is fully seated in the body rear end panel.
- Install the tail lamp bulb into the tail lamp socket.
- Align the tabs on the tail lamp socket to the notches in the tail lamp assembly.
- Twist the tail lamp socket clockwise to secure the tail lamp socket to the tail lamp assembly.
- Install the tail lamp assembly to the body.
- Install the fasteners that secure the tail lamp assembly to the body.
- Connect the tail lamp connector.
- Install the rear compartment sill plate. Refer to Rear Compartment Sill Trim Plate Replacement in Body Rear End.
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the fasteners to 6 N·m (53 lb in).
