GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Buick 🢒 2001 🢒 LeSabre 🢒 Body and Accessories 🢒 Body Control System 🢒 HVAC Control Module Replacement

Removal Procedure

    Object Number: 443866 Size: SH
  1. Remove the right I/P accessory trim plate. Refer to Instrument Panel Accessory Trim Plate Replacement - Right Side in Instrument Panel, Gages and Console.
  2. Pinch the tabs on the control module and pull rearward on the HVAC control module to remove from the I/P.

Installation Procedure

    Object Number: 443866 Size: SH

    Important: The ignition must be in the OFF position when installing the HVAC control module to ensure proper actuator calibration.

  1. Install the HVAC control module and ensure that the tabs are fully seated to the I/P.
  2. Install the right I/P accessory trim plate. Refer to Instrument Panel Accessory Trim Plate Replacement - Right Side in Instrument Panel, Gages and Console.

    3. Important: Do not adjust any controls on the HVAC control module while the HVAC control module is self-calibrating. If interrupted improper HVAC performance will result.

    The engine must be running for proper calibration to occur.

  3. Start the engine and let run for one minute.