Schematic Reference: Outside Rearview Mirror Schematics

Did you perform the Door Systems Diagnostic System Check?

Go to Step 2

Go to Diagnostic System Check - Door Systems

Verify that the Heated Mirrors Inoperative complaint is present.

Does the heated mirrors system operate as described in the Description and Operation?

Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems

Go to Step 3

3

1. Turn OFF the ignition.
2. Disconnect the mirror harness connector from the door module associated with the inoperative outside mirror.
3. Connect a test lamp between the mirror heating element ground circuit, and the mirror heating element supply voltage circuit at the door module pins.
4. Turn ON the ignition, with the engine OFF.

Does the test lamp illuminate?

Go to Step 9

Go to Step 4

With the test lamp still connected between the mirror heating element ground circuit and the mirror heating element supply voltage circuit at the door module pins, command the mirrors to heat by turning On the rear defroster.

Does the test lamp illuminate?

Go to Step 5

Go to Step 9

5

1. Turn OFF the ignition.
2. Connect the mirror harness connector to the door module associated with the inoperative outside mirror.
3. Carefully remove the mirror face (glass) from the mirror that does not heat. Refer to Outside Rearview Mirror Glass Replacement or Mirror Face Replacement - Outside Electrochromatic .
4. Disconnect the heated mirror circuit connectors from the mirror face.
5. Connect a test lamp between the heated mirror circuit connectors.
6. Turn ON the ignition, with the engine OFF.

Does the test lamp illuminate?

Go to Step 7

Go to Step 6

With the test lamp still connected between the heated mirror circuit connectors, command the mirror to heat by turning ON the rear window defroster.

Does the test light illuminate?

Go to Step 8

Go to Step 7

Inspect for poor connections at the harness connector of the inoperative outside rear view mirror. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems.

Did you find and correct the condition?

Go to Step 13

Go to Step 12

Inspect for poor connections at the harness connector of the inoperative outside rear view mirror face. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems.

Did you find and correct the condition?

Go to Step 13

Go to Step 10

Inspect for poor connections at the harness connector of the inopertive outside rear view mirror. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems.

Did you find and correct the condition?

Go to Step 13

Go to Step 11

Replace the inoperative outside rear view mirror face. Refer to Outside Rearview Mirror Glass Replacement or Mirror Face Replacement - Outside Electrochromatic .

Did you complete the replacement?

Go to Step 13

--

Replace the door module of the inoperative mirror. Refer to Door Control Module Replacement .

Did you complete the replacement?

Go to Step 13

--

Replace the inoperative outside rear view mirror. Refer to Power Mirror Replacement .

Did you complete the replacement?

Go to Step 13

--

Operate the system in order to verify the repair.

Did you correct the condition?

System OK

Go to Step 2