Removal Procedure
- Disable the SIR system. Refer to Disabling the SIR System in SIR.
- Remove the steering column trim covers. Refer to Steering Column Trim Covers Replacement - On Vehicle .
- Remove the shift lever from the linear shift assembly. Refer to Shift Lever Replacement - On Vehicle .
- Disconnect the automatic transmission shift lock actuator from the linear shift assembly.
- Disconnect the transmission shift cable from the linear shift assembly.
- Disconnect the park lock cable assembly (1).
- Insert a small screwdriver into the slot on the lock module assembly and push against the parklock cable locking tab to remove the parklock cable.
- Remove the linear shift assembly retaining screws.
- Remove the linear shift assembly.
Caution: This vehicle is equipped with a Supplemental Inflatable Restraint (SIR) System. Failure to follow the correct procedure could cause the following conditions:
• Air bag deployment • Personal injury • Unnecessary SIR system repairs • Refer to SIR Component Views in order to determine if you are performing service on or near the SIR components or the SIR wiring. • If you are performing service on or near the SIR components or the SIR wiring, disable the SIR system. Refer to Disabling the SIR System.
Installation Procedure
- Install the linear shift assembly and retaining screws.
- Connect the park lock cable assembly (1) to the lock module assembly.
- Connect the transmission shift cable to the linear shift assembly.
- Connect the automatic transmission shift lock actuator to the linear shift assembly.
- Adjust the automatic transmission shift lock. Refer to Automatic Transmission Shift Lock Actuator Replacement in Shift Lock Control.
- Install the shift lever. Refer to Shift Lever Replacement - On Vehicle
- Install the steering column trim covers. Refer to Steering Column Trim Covers Replacement - On Vehicle .
- Enable the SIR system. Refer to Enabling the SIR System in SIR.
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the linear shift assembly retaining screws to 10 N·m
(89 lb in).
