GM Service Manual Online
For 1990-2009 cars only

Tools Required

J 44298 Driver Air Bag Removal Tool

Removal Procedure


    Object Number: 726362  Size: SH

    Caution: When you are carrying an undeployed inflator module:

       • Do not carry the inflator module by the wires or connector on the inflator module
       • Make sure the bag opening points away from you
    When you are storing an undeployed inflator module, make sure the bag opening points away from the surface on which the inflator module rests. When you are storing a steering column, do not rest the column with the bag opening facing down and the column vertical. Provide free space for the air bag to expand in case of an accidental deployment. Otherwise, personal injury may result.

    Caution: A deployed dual stage inflator module will look the same whether one or both stages were used, always assume a deployed dual stage inflator module has an active stage 2. Improper handling or servicing can activate the inflator module and cause personal injury.

  1. Disable the SIR system. Refer to Disabling the SIR System .
  2. On the back side of the steering wheel you will find 4 openings for removing the driver inflator module.
  3. Position the steering wheel so that 2 of the opening/holes are on top.
  4. Adjust and install J 44298 into two of the holes.
  5. Important: Seat the air bag removal tool all the way to perform properly.

  6. Push the handle back towards the I/P, releasing the 2 spring-loaded fasteners at the same time.
  7. Turn the steering wheel and open J 44298 l. Use one of the tool fingers to remove cruise control lever cover in order to gain access.
  8. Position J 44298 and insert the tool into place around the cruise control lever. Repeat the procedure that you used on other two opening/holes.
  9. Pull the driver inflator module gently away from the steering wheel.

  10. Object Number: 709895  Size: SH

    Important: Note the driver inflator wire routing positions, the redundant control routing positions, and the horn wire routing positions for the correct re-assembly.

  11. Remove the connector position assurance (CPA) (4) and the electrical connectors from the driver inflator module.
  12. Remove the horn grounded lead (2) from the threaded hole in the steering wheel.
  13. Rotate the horn contact lead counterclockwise ¼ turn.
  14. Remove the horn contact lead (2) from the steering column cam tower.
  15. Remove the inflatable restraint steering wheel module (5).
  16. Fully deploy the module before disposal. If the module was replaced under warranty, fully deploy and dispose of the module after the required retention period. Refer to Inflator Module Handling and Scrapping .

Installation Procedure


    Object Number: 709895  Size: SH
  1. Connect the horn ground lead (2) into the lower left threaded hole in the steering wheel.
  2. Connect the horn contact lead into the steering column cam tower.
  3. Rotate the horn contact turn ¼ turn clockwise to lock.
  4. Connect the inflator module electrical connectors and CPA (4).
  5. Important: Route the driver inflator wires, the redundant control wires, and the horn wires correctly.

  6. Align the driver inflator module fasteners to the steering column fastener holes.
  7. Push the driver inflator module firmly into the steering column to engage the fasteners.
  8. Enable the SIR system. Refer to Enabling the SIR System .