Tools Required

J 45299 Engine Preluber

Important: A constant/continuous flow of clean engine oil is required in order to properly prime the engine. Be sure to use an approved engine oil as specified in the owners manual.

1. Remove the engine oil filter and fill with clean engine oil.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

2. Install the oil filter.

Tighten
Tighten the oil filter to 30 N·m (22 lb ft).

3. Locate the oil pressure sensor (1) on left side of engine and remove.
4. Install the 1/4 inch adapter P/N 509373.



5. Install the flexible hose to the adapter and open the valve.
6. Pump the handle on J 45299 to flow a minimum of 1-2 quarts (1-1.9 liters) of engine oil. Observe the flow of engine oil through the flexible hose and into the engine assembly.
7. Close the valve and remove the flexible hose and adapter from the engine.
8. Install the oil pressure sensor.

Tighten
Tighten the oil pressure sensor to 16 N·m (12 lb ft).

9. Top off the engine oil to the proper level.