Removal Procedure
- Remove the right sound insulator. Refer to
Instrument Panel Insulator Panel Replacement - Right Side
In Instrument Panel, Gages
and Console.
- Remove the instrument panel compartment. Refer to
Instrument Panel Storage Compartment Replacement
in Instrument
Panel, Gages and Console.
- Remove the Dash Integration Module (DIM) from the bracket and position
aside.
- Remove the rear DIM bracket screws and lower the bracket enough to access
the blower module.
- Disconnect the electrical connector (1).
- Remove the blower control module retaining screw.
- Remove the blower control module.
Installation Procedure
- Install the blower control module.
Notice: Use the correct fastener in the correct location. Replacement fasteners
must be the correct part number for that application. Fasteners requiring
replacement or fasteners requiring the use of thread locking compound or sealant
are identified in the service procedure. Do not use paints, lubricants, or
corrosion inhibitors on fasteners or fastener joint surfaces unless specified.
These coatings affect fastener torque and joint clamping force and may damage
the fastener. Use the correct tightening sequence and specifications when
installing fasteners in order to avoid damage to parts and systems.
- Install the retaining screw.
Tighten
Tighten the screw to 2 N·m (18 lb in).
- Connect the electrical connector (1).
- Install the DIM bracket screws.
Tighten
Tighten the screws to 1.4 N·m (12 lb in).
- Install the DIM into the bracket.
- Install the instrument panel compartment. Refer to
Instrument Panel Storage Compartment Replacement
in Instrument
Panel, Gages and Console.
- Install the right sound insulator. Refer to
Instrument Panel Insulator Panel Replacement - Right Side
in Instrument Panel, Gages
and Console.
- Recalibrate the actuator. Refer to
Actuator Recalibration
.