For 1990-2009 cars only
Removal Procedure
- Remove the left rear compartment trim panel. Refer to Rear Compartment Trim Panel Replacement in Body Rear End.
- Loosen the digital receiver mounting bolts (1).
- Slide the receiver and the bracket up and out of the keyhole slots in the rear reinforcement panel.
- Disengage the electrical connector from the connection position assurance (CPA) (1).
- Disconnect the electrical connector (3) from the digital radio receiver (1).
- Disconnect the antenna connector (2).
- Remove the digital receiver and bracket (1) from the vehicle.
- Remove the nuts (1) securing the receiver bracket to the digital radio receiver.
- Remove the digital radio receiver from the receiver bracket.
Important: Do NOT swap digital radio receivers between vehicles. Swapping digital receivers between vehicles will activate the digital radio theftlock, "XM theftlock" will be displayed.
Installation Procedure
- Install the digital radio receiver to the receiver bracket.
- Install the nuts (1) that secure the receiver to the bracket.
- Engage the electrical connector to the CPA.
- Connect the antenna connector (2) to the digital receiver (1).
- If removed, loosely install the mounting bolts to the bracket to a depth of 3-4 threads.
- Align the receiver and bracket assembly to the keyhole slots in the rear reinforcement, with the electrical connection end towards the rear compartment floor.
- Install the receiver mounting bolts (1) to the keyhole slots. Slide the receiver and bracket down.
- Install the left rear compartment trim panel. Refer to Rear Compartment Trim Panel Replacement in Body Rear End.
- Perform the setup procedure for the digital radio receiver. Refer to Digital Radio Receiver Setup .
Notice: Refer to Fastener Notice in the Preface section.
Tighten
Tighten the nuts to 7 N·m (62 lb in).
Connect the electrical connector (3) to the digital receiver (1).
Tighten
Tighten the bolts to 9 N·m (80 lb in).
