GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Buick 🢒 2003 🢒 LeSabre 🢒 Body and Accessories 🢒 Stationary Windows 🢒 Diagnostic System Check - Defogger

Test Description

The number(s) below refer to the step number(s) on the diagnostic table.

  1. Lack of communication may be due to a partial malfunction of the class 2 serial data circuit. The specified procedure will determine the particular condition.

    2.

  2. The Symptom Table will determine the correct diagnostic procedure to use.

    3.

  3. The presence of DTCs which begin with "U" indicate some other module is not communicating. The specified procedure will compile all the available information before tests are performed.

Step

Action

Yes

No

1

Install a scan tool.

Does the scan tool power up?

Go to Step 2

Go to Scan Tool Does Not Power Up in Data Link Communications

2

  1. Turn ON the ignition, with the engine OFF.
  2. Attempt to establish communication with the following:
    3. • The instrument panel module
    • The rear integration module (RIM)

Does the scan tool communicate with the modules?

Go to Step 3

Go to Scan Tool Does Not Communicate with Class 2 Device in Data Link Communications

3

Important: The engine may start during the following step. Turn OFF the engine as soon as you have observed the Crank power mode.

  1. Access the Class 2 Power Mode in the Diagnostic Circuit Check on the scan tool.
  2. Rotate the ignition switch through all positions while observing the ignition switch power mode parameter.

Does the ignition switch parameter reading match the ignition switch position for all switch positions?

Go to Step 4

Go to Power Mode Mismatch in Body Control System

4

Select the display DTCs function on the scan tool for the following modules:

    • The instrument panel module
    • The rear integration module (RIM)

Does the scan tool display any DTCs?

Go to Step 5

Go to Symptoms - Stationary Windows

5

Does the scan tool display DTCs that begin with "U"?

Go to Scan Tool Does Not Communicate with Class 2 Device in Data Link Communications

Go to Step 6

6

Does the scan tool display DTCs B1000, B1004, B1007, or B1009?

Go to Diagnostic Trouble Code (DTC) List in Body Control System

Go to Step 7

7

Does the scan tool display DTCs B1327?

Go to Diagnostic Trouble Code (DTC) List in Engine Electrical

Go to Symptoms - Stationary Windows