GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Buick 🢒 2003 🢒 LeSabre 🢒 Preface 🢒 Cautions and Notices 🢒 Power Seat Drive Cable Replacement

Removal Procedure
  1. Disable the SIR system. Refer to SIR Disabling and Enabling or to SIR Disabling and Enabling in SIR.
  2. Remove the seat cushion. Refer to Front Seat Cushion Replacement .
  3. If the cable is equipped with a position sensor, remove the sensor retention clip and disconnect the electrical connector.

    4. Object Number: 334291 Size: SH
  4. Squeeze the collars of the cable in order to release the cable.

    5. Object Number: 334292 Size: SH
  5. Pull the cable out of the fittings until the cable ends clear the fittings.
  6. Remove the cable or cable/sensor assembly.

Installation Procedure

    Object Number: 334292 Size: SH
  1. Install the cable or cable/sensor assembly by pushing the ends into the fittings until the cable retainers snap into place.
  2. If the cable is equipped with a position sensor, install the sensor retention clip and connect the electrical connector.
  3. Install the seat cushion. Refer to Front Seat Cushion Replacement .
  4. Enable the SIR system. Refer to SIR Disabling and Enabling or to SIR Disabling and Enabling in SIR.
  5. If the vehicle is equipped with memory seats, calibrate the seat. Refer to Memory Seat Calibration .