If your vehicle has the check tire pressure system, it can alert you to a large change in the pressure of one tire. The system won't alert you before you drive that a tire is low or flat. You must begin driving before the system will work properly.
The CHECK TIRE PRESSURE message will appear on the Driver Information Center (DIC) if pressure difference (low pressure) is detected in one tire. The check tire pressure system may not alert you if:
| • | more than one tire is low, |
| • | the vehicle is moving faster than 65 mph (105 km/h), |
| • | the system is not yet calibrated, |
| • | the tire treadwear is uneven, |
| • | the compact spare tire is installed, |
| • | tire chains are being used, or |
| • | the vehicle is being driven on a rough or frozen road. |
If the anti-lock brake system warning light comes on, the check tire pressure system may not be working properly. See your dealer for service. Also, see Antilock Brake System (ABS) Warning Light .
The check tire pressure system detects differences in tire rotation speeds that are caused by changes in tire pressure. The system can alert you about a low tire - but it doesn't replace normal tire maintenance. See Tires .
When the CHECK TIRE PRESSURE message appears on the Driver Information Center, you should stop as soon as you can and check all your tires for damage. If a tire is flat, see If a Tire Goes Flat . Also check the tire pressure in all four tires as soon as you can. See Inflation - Tire Pressure .
Any time you adjust a tire's pressure or have one or more tires repaired or replaced, you'll need to reset (calibrate) the check tire pressure system. You'll also need to reset the system whenever you rotate the tires, buy new tires and install or remove the compact spare.
Don't reset the check tire pressure system without first correcting the cause of the problem and checking and adjusting the pressure in all four tires. If you reset the system when the tire pressures are incorrect, the check tire pressure system will not work properly and may not alert you when a tire is low or high.
To reset (calibrate) the system:
- Turn the ignition switch to RUN.
- Press the GAGE INFO button on the DIC until TIRE PRESSURE appears on the display.
- Press and hold the DIC RESET button for about five seconds. After five seconds, the display will show TIRE PRESSURE RESET. If TIRE PRESSURE RESET does not appear in the display after about five seconds retry the process. If it does not work after two tries, see your dealer for service. After you release the DIC RESET button, TIRE PRESSURE NORMAL will appear in the display.
The system completes the calibration process during driving. Calibration time can take 45 to 90 minutes, depending on your driving habits. After the system has been calibrated, the system will alert the driver that a tire is low, up to a maximum speed of 65 mph (105 km/h).
