For 1990-2009 cars only
Removal Procedure
- Remove the door trim panel. Refer to Front Side Door Trim Panel Replacement .
- Remove the door module. Refer to Door Control Module Replacement .
- Remove the water deflector. Refer to Front Side Door Water Deflector Replacement .
- Remove the door handle fastener (2).
- Snap the lock and latch rods out of rod guide.
- Slide handle assembly forward to release the retainer tabs (1).
- Tilt the handle and remove the rods from the handle in the following sequence:
| 7.1. | Lock knob rod (1). |
| 7.2. | Handle lever rod (2). |
Installation Procedure
- Install the rods to the inside door handle in the following sequence:
- Align the retainer tabs (1) to the slots in the door and slide the door handle rearward.
- Snap the lock and latch rods into the rod guide.
- Install the inside door handle fastener (2).
- Install the water deflector. Refer to Front Side Door Water Deflector Replacement .
- Install the door module. Refer to Door Control Module Replacement .
- Install the door trim panel. Refer to Front Side Door Trim Panel Replacement .
| 1.1. | Handle lever rod (2). |
| 1.2. | Lock knob rod (1). |
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the fastener to 2 N·m (18 lb in).
