For 1990-2009 cars only
Removal Procedure
- Starting at the rear of the door, split the foam tape using a braided wire or a flat-bladed tool, inserted between the molding and the sheet metal. If using a flat-bladed tool, protect the surrounding surfaces. Use care not to damage the paint.
- Remove the door molding from the door.
- Clean the old adhesive from the door and the molding (if reusing) with 3M General Purpose Adhesive Cleaner 08984, or equivalent.
Installation Procedure
- If the molding is being reused, apply new adhesive tape to the molding.
- Align the molding using the locator pins.
- Remove the backing from the tape.
- Align and press the molding to the door. Ensure proper wetout of the adhesive by applying heavy hand pressure against the molding and rubbing along the entire length of the molding.
Important: Wear clean gloves or use a clean towel while performing this step.
