Removal Procedure
Notice:
• Handle the MAF sensor carefully. • Do not drop the MAF sensor in order to prevent damage to the MAF
sensor. • Do not damage the screen located on the air inlet
end of the MAF. • Do not touch the sensing elements. • Do not allow solvents and lubricants to come in contact with the
sensing elements. • Use a small amount of a soap based solution in order to aid in
the installation.
- Disconnect the engine harness electrical connector from the mass air flow/intake air temperature (MAF/IAT) sensor.
- Loosen the air cleaner outlet duct clamp at the throttle body.
- Loosen the air cleaner outlet duct clamp at the MAF/IAT sensor.
- Remove the air cleaner outlet duct.
- Remove the MAF/IAT sensor bolts.
- Remove the MAF/IAT sensor.
Installation Procedure
Notice:
• Handle the MAF sensor carefully. • Do not drop the MAF sensor in order to prevent damage to the MAF
sensor. • Do not damage the screen located on the air inlet
end of the MAF. • Do not touch the sensing elements. • Do not allow solvents and lubricants to come in contact with the
sensing elements. • Use a small amount of a soap based solution in order to aid in
the installation.
- Install the MAF/IAT sensor.
- Install the MAF/IAT sensor bolts.
- Install the air cleaner outlet duct.
- Tighten the air cleaner outlet duct clamp at the MAF/IAT sensor.
- Tighten the air cleaner outlet duct clamp at the throttle body.
- Connect the engine harness electrical connector to the MAF/IAT sensor.
Notice: Refer to Fastener Notice in the Preface section.
Tighten
Tighten the bolts to 4 N·m (35 lb in).
Tighten
Tighten the clamp to 4 N·m (35 lb in).
Tighten
Tighten the clamp to 4 N·m (35 lb in).
