J 45059 Angle Meter

1. Drain the engine oil and remove the oil filter. Refer to Engine Oil and Oil Filter Replacement .
2. Remove the right side wheel drive shaft. Refer to Wheel Drive Shaft Replacement .
3. Disconnect the engine harness electrical connector (2) from the oil pressure sensor.



4. Remove the oil pressure sensor.



5. Remove the oil filter adapter bolts.
6. Remove the oil filter adapter and gasket.
7. Remove the oil filter pressure relief valve and spring.
8. Clean the parts in a suitable solvent. Dry the parts.
9. Clean the oil filter adapter gasket mating surfaces.

1. Install the oil filter pressure relief valve spring and valve.
2. Position the oil filter adapter gasket and adapter.

Notice: Refer to Fastener Notice in the Preface section.

3. Install the oil filter adapter bolts.

Tighten
Tighten the bolts to 50 N·m (37 lb ft) plus an additional 3 degrees using J 45059 .




4. Install the oil pressure sensor.

Tighten
Tighten the sensor to 16 N·m (12 lb ft).




5. Connect the engine harness electrical connector (2) to the oil pressure sensor.
6. Install the right side wheel drive shaft. Refer to Wheel Drive Shaft Replacement .
7. Install the oil filter and fill the crankcase. Refer to Engine Oil and Oil Filter Replacement .
8. Inspect for leaks.