Removal Procedure
- Remove the intake manifold cover. Refer to
Intake Manifold Cover Replacement
.
- Disconnect the engine harness electrical connector (3) from the manifold absolute pressure (MAP) sensor.
- Carefully disengage the locking tabs holding the MAP sensor.
- Remove the MAP sensor.
Installation Procedure
- Ensure that the seal is installed on the MAP sensor and that the seal is not damaged.
- Position and install the MAP sensor. Ensure that the locking tabs engage to hold the MAP sensor.
- Connect the engine harness electrical connector (3) to the manifold absolute
pressure (MAP) sensor.
- Install the intake manifold cover. Refer to
Intake Manifold Cover Replacement
.