At the rear shock absorbers, the air tube connectors are held on with spring clips which snap into the grooves of the shock absorber air fittings. Air tube connectors are sealed using 2 O-rings.

Important: Before disconnecting any air tube, clean the connector and the surrounding area to prevent dirt and other foreign material from entering the ELC system.

To disconnect an air tube from a shock absorber, rotate the spring clip 90 degrees out of the slots, and pull the connector from the shock absorber.

Important: Ensure that the air tube is routed correctly and all fasteners are used.

To connect an air tube to a shock absorber, lubricate the 2 O-rings using silicone lubricant, rotate the spring clip 90 degrees into the slots, and push the air tube connector on the shock absorber fitting until spring clip snaps into fitting groove.

1. Raise the vehicle. Refer to Lifting and Jacking the Vehicle .



2. Remove the air tube from the air dryer.
3. Remove the bolt and the harness tie from the air compressor bracket.
4. Remove both rear wheels. Refer to Tire and Wheel Removal and Installation .



5. Disconnect the air tube from the left and right rear shock absorbers.
6. Remove the 2 metal clips from the air tube and the vehicle.
7. Remove the air tube with the 3 clips from the vehicle.

1. Connect the air tube to the air dryer.

Notice: Refer to Fastener Notice in the Preface section.

2. Install the air tube with the harness tie and the bolt on the air compressor bracket.



3. Install the air tube on the vehicle with 3 clips.
4. Connect the air tube to the left and right rear shock absorbers.
5. Install 2 metal clips on the air tube and the vehicle. Place each clip immediately forward of the wheel house fold-over tabs on the LH and RH side of the vehicle.
6. Install both rear wheels. Refer to Tire and Wheel Removal and Installation .

Important: Before driving the vehicle, turn the ignition on and wait approximately 45 seconds. This will ensure that the air adjustable shock absorbers are filled with residual pressure.

7. Lower the vehicle. Refer to Lifting and Jacking the Vehicle .