Important: The park brake pedal assembly and the front park brake cable are serviced as a unit. The front park brake cable is not threaded and is not adjustable.

1. Ensure the park brake pedal is in the fully released position.
2. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .



3. Pull down on the front park brake cable.
4. Remove the cable (3) from the cable connector (1).
5. Lower the vehicle.
6. Remove the left closeout/insulator panel. Refer to Instrument Panel Insulator Panel Replacement - Left Side .
7. Remove the left knee bolster. Refer to Driver Knee Bolster Replacement .
8. Remove the left carpet retainer. Refer to Front Carpet Retainer Replacement .
9. Pull back the carpet.



10. Remove the park brake pedal assembly mounting nuts (1, 2).
11. Position the park brake pedal assembly away from the mounting studs.
12. Disconnect the electrical connector from the park brake warning lamp switch.
13. Remove the park brake pedal assembly.

1. Connect the park brake warning lamp switch electrical connector.
2. Install the park brake pedal assembly to the vehicle.

Notice: Refer to Fastener Notice in the Preface section.

3. Install the park brake pedal assembly mounting nuts (1, 2) to the vehicle.

Tighten
Tighten the park brake pedal assembly mounting nuts to 24 N·m (18 lb ft).




4. Raise the vehicle. Refer to Lifting and Jacking the Vehicle .
5. Install the front park brake cable (3) to the cable connector (1).
6. Lower the vehicle.



7. If installing a new park brake pedal assembly, you must remove the park brake pedal and cable set pin (1).

•	To set the park brake cable tension, rotate the tension release pin (1) 80 degrees and then pull down to remove.

•	Apply the park brake pedal 3 full cycles to complete the tension set.

8. Install the left knee bolster. Refer to Driver Knee Bolster Replacement .
9. Install the left closeout/insulator panel. Refer to Instrument Panel Insulator Panel Replacement - Left Side .
10. Install the left carpet retainer. Refer to Front Carpet Retainer Replacement .