For 1990-2009 cars only
Inspection Procedure
- Raise the vehicle. Refer to Lifting and Jacking the Vehicle .
- Raise the transmission/transaxle in order to create a slight tension in the transmission mount.
- Observe the transmission/transaxle mount while raising the transmission/transaxle. Replace the transmission/transaxle mount if the transmission/transaxle mount exhibits any of the following conditions:
- When replacing the transmission mounts or transmission brackets refer to the following procedures:
- If there is movement between the metal plate of the transmission/transaxle mount and its attaching points, lower the transmission/transaxle on the transmission/transaxle mount. Tighten the bolts or nuts attaching the transmission/transaxle mount to the frame or transmission/transaxle mount bracket. Refer to Fastener Tightening Specifications .
- For information on the engine mounts, refer to Engine Mount Inspection .
Important: Before replacing any transmission/transaxle mount due to suspected fluid loss, verify that the source of the fluid is the transmission/transaxle mount, not the engine, transmission/transaxle or accessories.
Notice: In order to avoid oil pan damage and possible engine failure, insert a block of wood that spans the width of the oil pan bottom between the oil pan and the jack support.
| • | The hard rubber surface is covered with heat check cracks. |
| • | The rubber is separated from the metal plate of the transmission/transaxle mount. |
| • | The rubber is split through the center of the transmission/transaxle mount. |
