Removal Procedure
Caution: Approved safety glasses and gloves should be worn when performing this
procedure to reduce the chance of personal injury.
Important: The mirror back is made so that the bottom edge fits into a slot and clip in place. This allow the mirror to rotate.
- Carefully push the mirror face toward the front of the car and downward on the inner edge, near the front door window glass, to allow access.
- Grasp the mirror face back and firmly pull it away from the mirror motor and housing.
It will be necessary to use a sharp jerking motion to release it from the housing.
- Lift the mirror back up and out to release the lower tabs.
- Disconnect the heated mirror wires, if equipped.
Installation Procedure
- Connect the heated mirror wires, if equipped.
- Using the palm of your gloved hand, press firmly on the center of the glass until the case seats onto the motor.
The mirror will make a snapping noise when properly seated.
- Inspect the mirror for proper operation.