Caution: Refer to Brake Fluid Irritant Caution in the Preface section.

Notice: Refer to Brake Fluid Effects on Paint and Electrical Components Notice in the Preface section.

1. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle.
2. Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation.
3. Clean all dirt and foreign material from the brake hose and the brake pipe fittings.




Important: Install a rubber cap or plug to the exposed brake pipe fitting end in order to prevent brake fluid loss and contamination.

4. Remove the brake pipe fitting from the brake hose.



5. Use a flat-bladed tool in order to remove the brake hose retainer from the brake hose.
6. Remove the brake hose from the brake hose bracket.



7. Remove the brake hose bolt from the brake caliper.
8. Remove the brake hose from the brake caliper.
9. Remove and discard the two copper brake hose gaskets. These gaskets may be stuck to the brake caliper and/or the brake hose end.
10. Install a rubber plug into the brake hose bolt hole of the brake caliper in order to prevent brake fluid loss and contamination.

1. Remove the rubber plug from the brake hose bolt hole of the brake caliper.




Important: Install NEW copper brake hose gaskets.

2. Assemble the brake hose bolt and the NEW copper brake hose gaskets to the brake hose.

Notice: Refer to Fastener Notice in the Preface section.

3. Install the brake hose bolt to the brake caliper.

Tighten
Tighten the brake hose bolt to 40 N·m (30 lb ft).





Notice: Make sure the brake hose is not twisted or kinked after installation. Damage to the hose could result.

4. Install the brake hose to the brake hose bracket.
5. Install the brake hose retainer to the brake hose.



6. Remove the rubber cap or plug from the exposed brake pipe fitting end.
7. Install the brake pipe fitting to the brake hose.

Tighten
Tighten the brake pipe fitting to 15 N·m (11 lb ft).

Caution: Do not move the vehicle until a firm brake pedal is obtained. Air in the brake system can cause the loss of brakes with possible personal injury.

8. Bleed the brake caliper at the brake caliper bleeder screw. Refer to Hydraulic Brake System Bleeding.
9. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation.
10. Lower the vehicle.