Important: Before replacing any engine mount due
to suspected fluid loss, verify that the source of the fluid is the engine mount,
not the engine or accessories.
- Install the engine support fixture. Refer to
Engine Support Fixture .
- Use the support fixture in order to raise the engine and create a slight
tension on the engine mount.
- Observe the engine mount while raising the engine. Replace the engine
mount if the mount exhibits any of the following conditions:
| • | The hard rubber surface is covered with heat check cracks. |
| • | The rubber is separated from the metal plate of the engine mount. |
| • | The rubber is split through the center of the engine mount. |
- Refer to the following procedures when replacing the engine mounts or
engine mount brackets:
- If there is movement between the metal plate of the engine mount and its
attaching points, lower the engine on the engine mount. Tighten the bolts or nuts
attaching the engine mount to the frame or engine mount bracket. Refer to
Fastener Tightening Specifications .
- For information on the transaxle mounts, refer to
Transmission Mount Inspection.
