Proper Installation of Air Dam Assembly During PDI

Air dam assemblies are being incorrectly installed during Pre-Delivery Inspection (PDI). The push pins for the air dam must be installed according to the instructions provided (from the top to bottom). The instructions for the air dam assembly are located in the trunk of the vehicle.

Important: The push pins for the belly pan to the fascia go from bottom up. The push pins for the air dam to the fascia go from top down.

1. Remove front push pins between the belly pan and fascia assembly in order to gain access to the top part of the fascia.
2. Install the air dam tabs to the fascia assembly. Make sure each tab is fully seated into the fascia slots.
3. Slightly push up on the belly pan in order to gain access to the top part of the fascia.




Important: Install the air dam push pins from the top going down.

4. Install the push pins to the air dam as shown above.

Important: The belly pan push pins are installed from bottom up.

5. Install the belly pan push pins.