Diagnostic Instructions
| • | Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure. |
| • | Review Strategy Based Diagnosis for an overview of the diagnostic approach. |
| • | Diagnostic Procedure Instructions provides an overview of each diagnostic category. |
DTC Descriptors
DTC B3567 01: Driver Information Center Select Switch Circuit Short to BatteryDTC B3567 59: Driver Information Center Select Switch Circuit/Component Protection Time-Out
Diagnostic Fault Information
Circuit | Short to Ground | Open/High Resistance | Short to Voltage | Signal Performance |
|---|---|---|---|---|
DIC Switch Signal Circuit | 1 | 1 | B3567 | B3567 |
DIC Switch Ground Reference Circuit | -- | 1 | -- | -- |
1. Driver Information Center (DIC) Switches Inoperative | ||||
Circuit/System Description
The driver information center (DIC) switch is a multiplexed switch. Battery power is provided to the DIC switch via the instrument panel cluster (IPC) with the DIC switch signal circuit pulled up to battery voltage in the IPC. The IPC also provides the DIC switch with a low reference circuit. The switch input to the IPC is pulled low when a switch is activated. The DIC switch is a momentary contact switch that connects a series of resistors in a resistor ladder format. The IPC monitors the DIC switch signal circuit to determine the DIC switch inputs. Each switch state - SET/RESET, VEHICLE INFORMATION, PERSONALIZATION (CUSTOMIZATION) - corresponds to a certain resistance value. The IPC determines the switch state by the voltage drop across the resistors.
The TRIP/FUEL switch is monitored on a separate circuit provided by the IPC. The TRIP/FUEL driver information center select menu switch signal circuit is monitored for a stuck switch but not a short to battery.
Conditions for Running the DTC
The ignition is in ACCESSORY or RUN.
Conditions for Setting the DTC
| • | The IPC detects that the DIC switch is stuck. |
| • | The IPC detects that the DIC switch return circuit is shorted to battery. |
Action Taken When the DTC Sets
The IPC ignores the DIC switch inputs.
Conditions for Clearing the DTC
| • | The DTC becomes history when the conditions for setting the DTC are no longer present. |
| • | The history DTC clears after 50 malfunction-free warm-up cycles. |
Diagnostic Aids
| • | When the Trip/Fuel switch is stuck, all other DIC switches will function correctly. When any of the 3 switches are stuck, only the Trip/Fuel switch will function correctly. |
| • | Only the DIC signal circuit can be diagnosed as shorted to battery. |
Reference Information
Schematic Reference
Connector End View Reference
Electrical Information Reference
Scan Tool Reference
Circuit/System Testing
- Ignition OFF, disconnect the DIC switch connector.
- Verify a test lamp does not illuminate when connected between the switch signal circuit terminal 1 and ground.
- If all circuits tests normal, test or replace the DIC switch.
| ⇒ | If the test lamp illuminates, check the switch signal circuit for a short to voltage. If all circuits test normal, replace the IPC. |
Repair Instructions
Perform the Diagnostic Repair Verification after completing the diagnostic procedure.
| • | Control Module References for the IPC replacement, setup and programming |
