Power Steering Pump Pulley Replacement RPO L26

Tools Required

1. Remove the drive belt. Refer to Drive Belt Replacement .
2. Remove the power steering pump. Refer to Power Steering Pump Replacement .
3. Use the J 25034-C to remove the power steering pulley from the power steering pump.

1. Use the J 25033-C to install the power steering pulley to the power steering pump.



2. Ensure that the axial tolerance of the power steering pulley on the power steering pump is within 0.25 mm (0.010 in).
3. Install the power steering pump to the engine. Refer to Power Steering Pump Replacement .
4. Install the pump drive belt. Refer to Drive Belt Replacement .
5. Bleed the power steering system. Refer to Power Steering System Bleeding .
6. Inspect the system for leaks.

Power Steering Pump Pulley Replacement RPO LD8

Tools Required

1. Remove the drive belt. Refer to Drive Belt Replacement.
2. Install a drain pan under the vehicle.
3. Disconnect the power steering return hose from the power steering reservoir.
4. Remove the power steering pump mounting bolt.



5. Raise the power steering pump up to access the power steering pulley.
6. Use the J 25034-C to remove the power steering pulley.

Important: Ensure the pulley is installed flush to within 0.25 mm (0.010 in) of the shaft.

1. Use the J 25033-C to install the power steering pulley to the pump.



2. Position the power steering pump to the engine.

Notice: Refer to Fastener Notice in the Preface section.

3. Install the power steering pump mounting bolt.

Tighten
Tighten the power steering pump mounting bolt to 50 N·m (37 lb ft).




4. Install the power steering return hose to the power steering reservoir.
5. Remove the drain pan from under vehicle.
6. Install the drive belt. Refer to Drive Belt Replacement.
7. Bleed the power steering system. Refer to Power Steering System Bleeding.